FrontGate - Transaction Mode
Transaction mode is in operation when Transactions are enabled in the admin tool. In this mode the FrontGate module collects and displays transactions on the screen. After entering a valid member ID the screen will have the following appearance:
If the members type has a valid entry transaction registered it will be automatically added to the transaction list.
At this point you can enter one of the following:
A valid transaction code | The transaction will be added to the displayed transaction list and the associated charge (if any) will be added to the total. |
A valid pass code | The pass will be added to the displayed transaction list. |
A valid payment method (CARD, CASH, CHEQUE, CHECK) |
When there is a non-zero total displayed a valid payment must be
entered before the transactions can be accepted. Once entered the
program moves to the acceptance screen (see below). Note: a payment method cannot be used to accept a zero balance transaction (i.e. nothing to pay) |
ACCEPT | This special code can be used only when there is nothing to pay for
(i.e. a total of zero). This moves the program to the acceptance screen
(see below). Note: this method cannot be used to accept a non-zero balance transaction (i.e. something to pay) |
A custom transaction code | If custom transaction codes have been enabled from the main CMS
program options and the code you enter doesn't match any of the above
conditions you are prompted to enter an amount.
The amount you specify will then be added to the total and the custom transaction added to the transaction list. |
Accepting The Transactions
Once you have entered all of the transactions and either a payment or acceptance code you will be prompted to accept the transactions.
Here you can enter either YES or NO or press the escape key (ESC). One of the following will take place:
Code | Action |
YES |
|
NO |
|
ESC key pressed |
|
Copyright 2014 SwiftTec - All Rights Reserved